Customer the,
so I'm gonna see if I this
sn it down.
Now I'm gonna make tool for pulling there.
So hopefully file on two sides.
So,
so
I
rotator
more later.
A lot of people don't like
see if I can see marks on it.
I can't. I certainly can't. So let's see what we got here.
Upside doesn't
there,
I want that so tight that you can't even put the stone.
I'm gonna take it to the very top and keep pressing
and pack it really nice and tight.
This saw that I've got from
UHS gentlemen there A for me
up to the top Reflect.
Now I can see that top little bit better. Pretty darn good.
So now I'm gonna take my, and I gonna try press it there,
but we know it's, we know it's gonna thing.
I'm gonna compress that sawdust a little bit more.
Hopefully that click I heard wasn't it sitting in place
already And it might very well have,
usually I do do something that is, I'll take it like that.
Close the top,
try it now.
Looks pretty right in there.
Five that in here.
12. Then I'll work out.
I do down because I can't do it up here on camera.
Be careful not to come in from the degrees
when come in at degrees.
You're doing stuff up underneath.
We're gonna right where it's,
we're gonna go ahead and uh, do
that very little piece lap hoping that we can fold
that in where it's not seen.
So let's give it a start here.
So I'm gonna start five degrees.
Now this tool can be in the palm of your hand.
You problems like this.
It's gonna push down. That's gonna compress it.
Push, flip this around. Come down over.
That's, that's midnight.
Two 30, come on. Leave.
So then we come on, go.
I think I
gonna start working all the around now and so what I'm,
maybe I can some what.
Okay. Shoulda made a point looking down.
Sometimes I forget I what I,
the bit
that dug into a bit
and it's actually Pul
stone mixed with a resin in the form
of can and
out
die, get a certain size and then pushed into a
And Cleaned up and pressurized a little.
They've got down making these, but they sure are
and they are like this one would be
turquoise mal.
It sure
got a nice smooth edge on here.
I'm gonna start whacking
even if I fall off a gonna
metal tool that you use on it.
Okay, So I think we're pretty much done there.
Let's take a close up look and see how we've done as
so how's
an easy way on.
Transcript provided for accessibility and search indexing.